2012

5 On the drop-down list, select Increment.
6 In the Properties palette, under Value Set, click Dist Increment, Ang
Increment, Hor Increment, or Ver Increment, and then enter an
incremental value for the parameter.
7 Click Dist Minimum, Ang Minimum, Hor Minimum, or Ver Minimum,
and then enter a minimum value for the parameter.
8 Click Dist Maximum, Ang Maximum, Hor Maximum, or Ver Maximum,
and then enter a maximum value for the parameter.
9 Click Block Editor tab ➤ Open/Save panel ➤ Save Block.
10 (Optional) If you are finished using the Block Editor, click Close Block
Editor.
To specify minimum and maximum values for a linear, polar, XY, or rotation
parameter
1 Ensure that the Properties palette is displayed. If not, click Tools
menu ➤ Palettes ➤ Properties.
2 Click Insert tab ➤ Block panel ➤ Block Editor.
3 In the Block Editor, select a linear, polar, XY, or rotation parameter.
4 In the Properties palette, under Value Set, click Dist Minimum, Ang
Minimum, Hor Minimum, or Ver Minimum, and then enter a minimum
value for the parameter.
5 Click Dist Maximum, Ang Maximum, Hor Maximum, or Ver Maximum,
and then enter a maximum value for the parameter.
6 Click Block Editor tab ➤ Open/Save panel ➤ Save Block.
7 (Optional) If you are finished using the Block Editor, click Close Block
Editor.
1010 | Chapter 23 Add Behaviors to Blocks (Dynamic Blocks)