2012

3 In the Property Lookup Table dialog box, at the bottom of a Lookup
Property column, do one of the following:
■ Click Read Only, and then select Allow Reverse Lookup from the list.
■ Click Allow Reverse Lookup, and then select Read Only from the list.
NOTE You can only select Allow Reverse Lookup if you have entered data in
the column.
4 Click OK.
Quick Reference
BACTION
Adds an action to a dynamic block definition.
BEDIT
Opens the block definition in the Block Editor.
BLOOKUPTABLE
Displays or creates a lookup table for a dynamic block definition.
BPARAMETER
Adds a parameter with grips to a dynamic block definition.
Use Chained Actions
Point, linear, polar, XY, and rotation parameters have a property called Chain
Actions. This property affects the parameter behavior if the parameter is part
of an action's selection set.
For example, you might include a point parameter in the selection set of a
stretch action that is associated with a linear parameter. When the linear
parameter is edited in a block reference, its associated stretch action triggers
a change in its selection set. Because the point parameter is included in the
selection set, the point parameter is edited by the change in the linear
parameter.
The following example shows a block definition in the Block Editor. The point
parameter (labeled Position) is included in the stretch action's selection set.
Add Actions to Dynamic Blocks | 1001