2012

7 Click Block Editor tab ➤ Open/Save panel ➤ Save Block.
8 If you are finished using the Block Editor, click Close Block Editor.
To edit a lookup table while the action bars are displayed in the Block Editor
1 Hover the cursor over the lookup action icon.
2 Right-click and select Display Lookup Table.
To display and add properties to a lookup table
1 In the Block Editor, double-click a lookup action in a dynamic block
definition.
2 In the Property Lookup Table dialog box, click Add Properties.
3 In the Add Parameter Properties dialog box, in the bottom-left corner of
the dialog box, click Add Input Properties or Add Lookup Properties.
4 In the Parameter Properties list, select the parameter properties you want
to add to the lookup table. Hold Ctrl down to select more than one
property.
5 Click OK.
6 In the Property Lookup Table dialog box, click an empty cell and do one
of the following:
■ Select a value from the drop-down list. (A drop-down list only displays
if a value set has been defined for the parameter.)
■ Enter a value.
7 Click OK.
To allow or disallow reverse lookup
1 Click Insert tab ➤ Block panel ➤ Block Editor.
2 In the Block Editor, double-click a lookup action in a dynamic block
definition.
1000 | Chapter 23 Add Behaviors to Blocks (Dynamic Blocks)