2012

Browse
Opens the Select Reference File dialog (a standard file selection dialog box on
page 1311).
Preview
Displays the image that you have selected to attach.
Path Type
Select the full (absolute) path, the relative path to the image file, or No Path,
the name of the image file (the image file must be located in the same folder
as the current drawing file).
Insertion Point
Specifies the insertion point for the selected image file. Specify On-Screen is
the default. The default insertion point is 0,0,0.
Specify On-Screen
Directs input at the Command prompt or the pointing device. If Specify
On-Screen is cleared, enter the insertion point in X, Y, and Z.
X
Sets the X coordinate value.
Y
Sets the Y coordinate value.
Z
Sets the Z coordinate value.
Scale
Specifies the scale factor of the selected image.
If
INSUNITS is set to “unitless” or if the image does not contain resolution
information, the scale factor becomes the image width in AutoCAD units. If
INSUNITS has a value such as millimeters, centimeters, inches, or feet, and
the image has resolution information, the scale factor is applied after the true
width of the image in AutoCAD units is determined.
Specify On-Screen
Allows you to input at the Command prompt or the pointing device. If Specify
On-Screen is cleared, enter a value for the scale factor. The default scale factor
is 1.
Scale Factor Field
944 | Chapter 10 I Commands