2012

Disassociate
Removes the associative quality from an associative hatch or fill.
Style
Specifies the method used to hatch or fill boundaries within the outermost
boundary.
Ignore Ignores all internal objects and hatches or fills through them.
Outer (Recommended) Hatches or fills inward from the outer boundary.
HATCH turns hatching or filling off if it encounters an internal island. This
option hatches or fills only the outermost level of the structure and leaves the
internal structure blank.
Normal Hatches or fills inward from the outer boundary. If HATCH encounters
an internal island, it turns off hatching or filling until it encounters another
island within the island.
Properties
Specifies new hatch properties for the selected hatch. For an explanation of
setting pattern and fill properties at the Command prompt, see -HATCH on
page 895.
Draw Order
Assigns a draw order to a hatch or fill. You can place a hatch or fill behind all
other objects, in front of all other objects, behind the hatch boundary, or in
front of the hatch boundary. (HPDRAWORDER system variable)
Add Boundaries
Modifies the boundaries of a hatch or fill by adding boundaries.
For more information, see Add: Pick Points or Add: Select Objects.
Remove Boundaries
Modifies the boundaries of a hatch or fill by removing boundaries.
For more information, see Remove Boundaries.
Recreate Boundary
Creates a polyline or region around the selected hatch or fill, and optionally
associates the hatch object with it.
For more information, see Recreate Boundary.
Associate
Specifies that the hatch or fill is associative. A hatch or fill that is associative
is updated when you modify its boundary objects.
-HATCHEDIT | 909