2012

Islands
Normal Island Detection Hatches or fills inward from the outer boundary.
If an internal island is encountered, hatching or filling is turned off until
another island within the island is encountered. (HPISLANDDETECTION
system variable)
Outer Island Detection Hatches or fills inward from the outer boundary. This
option hatches or fills only the specified area and leaves the internal islands
unaffected. (HPISLANDDETECTION system variable)
Ignore Island Detection Ignores all internal objects and hatches or fills
through them. (HPISLANDDETECTION system variable)
No Island Detection Turns off island detection.
Draw Order Assigns a draw order to a hatch or fill. You can place a hatch or
fill behind all other objects, in front of all other objects, behind the hatch
boundary, or in front of the hatch boundary. (HPDRAWORDER system
variable)
Close Panel
Close Hatch Editor Exits the Hatch Editor and closes the contextual tab.
The ENTER and ESC keys can also be used to exit the Hatch Editor.
-HATCHEDIT
Quick Reference
See also:
■ Modify Hatches and Fills
Uses command prompts to modify hatch-specific properties, such as pattern,
scale, and angle for an existing hatch or fill.
List of Prompts
The following prompts are displayed.
Select hatch object:
Enter hatch option [
DIsassociate/Style/Properties/DRaw order/ADd
boundaries
/Remove boundaries/recreate Boundary/ASsociate/separate
Hatches
/Origin on page 910/ANnotative/hatch COlor/LAyer/Transparency]
<Properties>: Enter an option or press Enter
908 | Chapter 9 H Commands