2012

■ A Fonts folder is created, if necessary.
■ A PlotCfgs folder is created, if necessary.
■ A SheetSets folder is created to hold all support files for sheet sets, if
necessary. The sheet set data (DST) file, however, is placed in the root
folder.
NOTE This option is not available if you're saving a conversion package to an
Internet location.
Source Root Folder Defines the source root folder for relative paths of
drawing-dependent files, such as external references. The source root folder
also contains the sheet set data (DST) file when a sheet set is converted.
Browse [...] Opens a standard file selection dialog box, in which you can
navigate to a location where you create the conversion package.
Place All Files in One Folder All files are installed to a single, specified target
folder when the conversion package is installed.
Keep Files and Folders As Is Preserves the folder structure of all files in the
conversion package, facilitating ease of installation on another system. This
option is not available if you're saving a conversion package to an Internet
location.
Actions
Create backup (*.bak) Files Backup (.bak) files of are created during the
conversion. This option is only active when the Conversion Package Type is
set to In-place (Overwrite Files).
Convert Digitally Signed Files Controls whether digitally signed drawings
are converted.
Check and Fix Errors When active, drawings are checked for the presence of
errors. Drawings are automatically recovered if errors are found. Set Default
Plotter to ‘None’ Changes the printer/plotter setting in the conversion package
to None. Your local printer/plotter settings are usually not relevant to the
recipient.
Bind External References Opens a standard file selection dialog box, in which
you can navigate to a location where you create the conversion package.
Prompt for Password Opens the Archive - Set Password dialog box, before
completing the conversion, where you can specify a password for your
conversion package.
Modify Conversion Setup Dialog Box | 719