2012

NOTE The Path Type group is disabled when you’re attaching a DWF or DWFx
file that is stored on the Vault client server. This information is automatically entered
by the Vault.
Insertion Point
Specifies the insertion point for the selected DWF file. Specify On-Screen is
the default. The default insertion point is 0,0,0.
Specify On-Screen Directs input at the Command prompt or the pointing
device. If Specify On-Screen is cleared, enter the insertion point in X, Y, and
Z.
Scale
Specifies the scale factor of the selected DWF underlay.
If
INSUNITS is set to “unitless” or if the underlay does not contain resolution
information, the scale factor becomes the underlay width in AutoCAD units.
If INSUNITS has a value such as millimeters, centimeters, inches, or feet, and
the underlay has resolution information, the scale factor is applied after the
true width of the underlay in AutoCAD units is determined.
Specify On-screen Allows you to input at the Command prompt or the
pointing device. If Specify On-Screen is cleared, enter a value for the scale
factor. The default scale factor is 1.
Scale Factor Field Enter a value for the scale factor. The default scale factor
is 1.
Rotation
Specifies the rotation angle of the selected DWF underlay.
Specify on-screen If Specify On-Screen is selected, you may wait until you
exit the dialog box to rotate the object with your pointing device or enter a
rotation angle value at the Command prompt.
Angle If Specify On-Screen is cleared, enter the rotation angle value in the
dialog box. The default rotation angle is 0.
Show Details
Displays the DWF file path.
Found In Displays the path where the DWF file is located.
Saved Path Displays the path that is saved with the drawing when the DWF
file is attached. The path is dependent upon the Path Type setting.
Attach DWF Underlay Dialog Box | 705