2012

Specify outside diameter of donut <current>: Specify a distance or press Enter
Specify center of donut or <exit>: Specify a point (1) or press Enter to end the
command
The location of the donut is set based on the center point. After you specify
the diameters, you are prompted for the locations at which to draw donuts.
A donut is drawn at each point specified (2). How the interior of a donut is
filled depends on the current setting of the FILL command.
DOWNLOADMANAGER
Quick Reference
See also:
■ Browse Material Libraries
Reports the status of the of the current download.
Summary
If a download was previously interrupted, it provides an opportunity to
continue downloading. Currently, this command applies only to downloading
the Autodesk Medium Image Library.
List of Prompts
No prompts are displayed.
DOWNLOADMANAGER | 663