2012

Table Of Contents

The value is expressed as a percentage, and the valid range is 0 to 100. The

inspection rate is displayed in the rightmost section of the inspection

dimension when the Inspection Rate check box is selected.

-DIMINSPECT

Quick Reference

See also:

■ Convert Dimensions into Inspection Dimensions

List of Prompts

The following prompts are displayed.

Add inspection data on page 598 or [Remove on page 598] <Add>: Enter an option

or press Enter

Add

Adds an inspection dimension to the selected dimensions.

Round Creates a frame with semi-circles on the two ends; the fields within

the frame are separated by vertical lines.

Angular Creates a frame with lines that form a 90-degree angle on the two

ends; the fields within the frame are separated by vertical lines.

None Specifies that no frame is drawn around the values; the fields are not

separated by vertical lines.

None No label is displayed with the inspection dimension.

Remove

Removes the inspection dimension from the selected dimensions.

DIMJOGGED

Quick Reference