2012

2Lines
Selects two line objects. The lines are made parallel and the aligned constraint
controls the distance between the two lines.
First Line Select the first line to be constrained.
Second Line to Make Parallel Select the second line to constrain the distance
between the two selected lines.
Dimension Line Location
Dimension Line Location on page 513
DCANGULAR
Quick Reference
See also:
■ Apply Dimensional Constraints
Constrains the angle between line or polyline segments, the angle swept out
by an arc or a polyline arc segment, or the angle between three points on
objects.
Access Methods
Button
Ribbon: Parametric tab ➤ Dimensional panel ➤ Angular
Menu: Parametric ➤ Dimensional Constraints ➤ Angular
Toolbar: Parametric ➤ DIMCONSTRAINT dropdown
Summary
This command is equivalent to the Angular option in
DIMCONSTRAINT on
page 587.
When you enter or edit an angle value that is either negative or is greater than
360 degrees, the number entered is stored for the expression (for example,
390), but the value displayed is based on the formatting of the units (for
example, 30 if decimal degrees).
514 | Chapter 5 D Commands