2012

Axis Endpoint Specifies the endpoint location for the cone axis. The axis
endpoint is the top point of the cone or the center point of the top face of
the cone frustum (Top Radius option). The axis endpoint can be located
anywhere in 3D space. The axis endpoint defines the length and orientation
of the cone.
Top Radius Specifies the top radius of the cone, creating a cone frustum.
Initially, the default top radius is not set to any value. During a drawing session,
the default value for the top radius is always the previously entered top radius
value for any solid primitive.
Diameter Specifies the diameter for the base of the cone.
Initially, the default diameter is not set to any value. During a drawing session,
the default value for the diameter is always the previously entered diameter
value for any solid primitive.
3P (Three Points)
Defines the base circumference and base plane of the cone by specifying three
points.
■
2Point on page 356
■ Axis Endpoint on page 357
■ Top Radius on page 357
2P (Two Points)
Defines the base diameter of the cone by specifying two points.
■
2Point on page 356
■ Axis Endpoint on page 357
■ Top Radius on page 357
CONE | 357