2012

smoothness of 3D curved solids, such as a cone, in a shaded or hidden visual
style with the FACETRES system variable.
Use the Top Radius option to create a cone frustum.
Initially, the default base radius is not set to any value. During a drawing
session, the default value for the base radius is always the previously entered
base radius value for any solid primitive.
List of Prompts
The following prompts are displayed.
Specify center point of base or [
3P on page 357/2P on page 357/Ttr on page
358/
Elliptical on page 358]: Specify a point (1) or enter an option
Specify base radius or [
Diameter on page 357] <default>: Specify a base radius,
enter d to specify a diameter, or press Enter to specify the default base radius value
Specify height or [2Point on page 356/Axis endpoint on page 357/Top radius
on page 357] <default>: Specify a height, enter an option, or press Enter to specify
the default height value
Center Point of Base
2Point Specifies that the height of the cone is the distance between the two
specified points.
356 | Chapter 4 C Commands