2012

Distance 1 Sets the distance of the first chamfer edge from the selected edge.
The default value is 1.
Distance 2 Sets the distance of the second chamfer edge from the selected
edge. The default value is 1.
Loop Chamfers all edges on a single face. For any edge, there are two possible
loops. After selecting a loop edge you are prompted to Accept the current
selection or choose the Next loop.
Expression Controls the chamfer distance with a mathematical expression.
See Control Geometry with the Parameters Manager for a list of operators and
functions allowed.
CHANGE
Quick Reference
See also:
■ Display and Change the Properties of Objects
Changes the properties of existing objects.
List of Prompts
The following prompts are displayed
Select objects:
Specify
change point or [Properties]: Specify a new point, or press Enter to enter
new values
Specify Objects
If you select lines and other changeable objects in the same selection set, you
get varying results depending on the object selection sequence. The easiest
way to use CHANGE is to select only lines in a selection set or select only
objects other than lines in a selection set.
Except for zero-thickness lines, the objects selected must be parallel to the
current user coordinate system (UCS).
Change Point or Values
Changes the selected objects. The result depends on the type of objects you
select.
324 | Chapter 4 C Commands