2012

BPARAMETER
Quick Reference
See also:
■ Add Parameters to Dynamic Blocks
Adds a parameter with grips to a dynamic block definition.
Access Methods
Panel
Ribbon: Block Editor contextual tab ➤ Action Parameters panel
Summary
You can use the bparameter command only in the
Block Editor on page 237.
A parameter defines custom properties for the block reference. After you add
a parameter, you must associate an action with the parameter to make the
block dynamic.
List of Prompts
The following prompts are displayed.
Enter parameter type [
Alignment/Base on page
271/
pOint/Linear/Polar/XY/Rotation/Flip/“Visibility”/looKup] <last>: Enter a
parameter type
Alignment
Button
Block Editor contextual tab ➤ Action Parameters panel ➤ Action Parameters
drop-down ➤ Alignment
270 | Chapter 3 B Commands