2012

Summary
When you insert a dynamic block reference in a drawing, you can use the Ctrl
key to cycle through the grips that have cycling turned on in the block
definition. The grip you select as you cycle is used as the insertion point for
the block reference.
List of Options
The following options are displayed.
Grip Cycling List
Lists the grips in the dynamic block definition. A check mark in the cycling
column indicates that cycling is turned on for that grip.
Move Up
Moves the selected grip up in the cycling order for the dynamic block reference.
Move Down
Moves the selected grip down in the cycling order for the dynamic block
reference.
Cycling
Turns cycling on or off for the selected grip. A check mark in the cycling
column indicates that cycling is turned on for that grip.
BEDIT
Quick Reference
See also:
■ Define Blocks
■ Modify Blocks
■ Modify Dynamic Block Definitions
Opens the block definition in the Block Editor.
230 | Chapter 3 B Commands