2012

CharacteristicsValid Objects or Points
■ When you select an arc, a three-point
angular constraint is created. The angle
vertex is at the center of the arc and
the angle endpoints of the arc are at
the endpoints of the arc.
When you enter or edit an angle value that is either negative or is greater than
360 degrees, the number entered is stored for the expression (for example,
390), but the value displayed is based on the formatting of the units (for
example, 30 if decimal degrees).
When an expression with variables evaluates to greater than 360 or less than
-360, the constraint value is displayed in the Parameters Manager palette based
on the units of the drawing.
Radial
Button
Block Editor contextual tab ➤ Dimensional panel ➤ Radius
Creates a radial constraint parameter for a circle, arc, or polyline arc segment.
CharacteristicsValid Objects or Points
Circle
■ Constrains the radius of the circle or
arc.
Arc
Diameter
Button
Block Editor contextual tab ➤ Dimensional panel ➤ Diameter
BCPARAMETER | 227