2012

library specifies the slide library file (extension .slb) into which the slide files
(extension .sld) are added. slidelist specifies a list of slide files. If you want to
specify a file extension, it must be .sld.
SLIDELIB reads a list of slide file names. This list is normally supplied by
redirecting a list of files (one per line in another file created using a text editor
or a user-supplied utility program) to standard input.
The operating system commands shown below will create a slidelist file that
can be used with SLIDELIB. All the slide files you want to compile into a slide
library should be placed in a single directory. At a DOS prompt (version 5.0
or newer), enter the following:
dir *.sld /b > mylist
This creates the mylist file, which you can pass to SLIDELIB. You can also create
the mylist file with a text editor by listing the slide file names (and paths, if
necessary), such as lobby, d:\slides\office, and \aec\slides\stairs. The slide file
name, but not the drive and directory information, is saved in the library file.
Because only the file name is included, a library can contain slides with the
same name from different directories, but only one of the slides can be
accessed.
To generate the slide library mlib from mylist, enter the following:
slidelib mlib < mylist
This entry creates the file mlib.slb, which contains the names and definitions
of the slides listed in mylist.
WARNING Do not delete your original slides. SLIDELIB has no provision for
updating a slide library once it is created. If you want to add or delete a slide,
update the slidelist file and re-create the library with SLIDELIB. All the original slides
must be present in order to do this.
SLIDELIB | 2669