2012

0Initial value:
Stores whether the default method used for the SPLINE command is fit points
or control vertices.
Create splines using fit points0
Create splines using control vertices1
NOTE SPLMETHOD always defaults to 0 when AutoCAD starts.
SPLPERIODIC
Quick Reference
See also:
■ Draw Splines
IntegerType:
User-settingsSaved in:
1Initial value:
Controls whether closed splines and NURBS surfaces are generated with
periodic properties to maintain the smoothest continuity at the closure point
or seam.
Creates closed splines and NURBS surfaces with the
method used in AutoCAD 2011 and earlier releases.
0
Creates periodic closed splines and closed NURBS surfaces,
for the smoothest (C2) continuity. (Recommended)
1
SSFOUND
Quick Reference
See also:
■ Publish, Transmit, and Archive Sheet Sets
SPLPERIODIC | 2547