2012

Table Of Contents

■ Displays unsmoothed mesh objects, even if they have been smoothed.

■ Displays the edges of 3D faces and polyface meshes.

NOTE To control the display for splines, use the CVSHOW on page 416 and the

CVHIDE on page 410 commands.

SPLINESEGS

Quick Reference

See also:

■ Modify Polylines

IntegerType:

DrawingSaved in:

8Initial value:

Sets the number of line segments to be generated for each spline-fit polyline

generated by the Spline option of the PEDIT command.

Enter a non-zero integer between -32768 to 32767. If you set SPLINESEGS to

a negative value, segments are generated using the absolute value of the setting

and then a fit-type curve is applied to those segments. Fit-type curves use arcs

as the approximating segments. Using arcs yields a smoother generated curve

when few segments are specified, but the curve can take longer to generate.

SPLINETYPE

Quick Reference