2012

Specify Selection Set Determines the objects that will be mirrored about the
flip parameter reflection line.
Move
Button
Block Editor contextual tab ➤ Action Parameters panel ➤ Actions drop-down
➤ Move
Specifies that the selection set of objects moves when the action is triggered
in a dynamic block reference. A move action can be associated with a point,
linear, polar, or XY parameter.
Select Parameter
Select Parameter on page 205
Select Objects
Select Objects on page 205
Specify Action Location
Specify Action Location on page 205
Specify Parameter Point When a linear or polar parameter is selected,
determines whether the start or end point of the parameter is used to determine
the base point of the action.
When an XY parameter is selected, determines which corner of the parameter
will be associated with the action. The objects selected for the action will be
moved relative to this point.
Multiplier When
BACTIONBARMODE on page 2176 is set to 0 and the action
is triggered, changes the associated parameter value by the specified distance.
Offset When BACTIONBARMODE on page 2176 is set to 0 and the action is
triggered, increases or decreases the angle of the selected parameter by the
specified value.
XY When an XY parameter is selected, specifies whether the distance applied
to the action is the parameter's X distance, Y distance, or XY distance from the
parameter's base point.
Rotate
Button
Block Editor contextual tab ➤ Action Parameters panel ➤ Actions drop-down
➤ Rotate
206 | Chapter 3 B Commands