2012

Controls whether object snaps are automatically projected onto a plane parallel
to the XY plane of the current UCS at the current elevation.
Osnap uses the Z-value of the specified point0
Osnap substitutes the Z-value of the specified point with
the elevation (ELEV on page 740) set for the current UCS
1
OSOPTIONS
Quick Reference
See also:
■ Use Object Snaps
BitcodeType:
RegistrySaved in:
3Initial value:
Automatically suppresses object snaps on hatch objects and geometry with
negative Z values when using a dynamic UCS.
The setting is stored as a bitcode using the sum of the following values:
Object snaps operate on hatch objects, and on geometry
with negative Z values when using a dynamic UCS
0
Object snaps ignore hatch objects1
Object snaps ignore geometry with negative Z values
during use of a dynamic UCS
2
2456 | Chapter 40 O System Variables