2012

RegistrySaved in:
2Initial value:
Specifies the keys for selection cycling and the behavior for Ctrl+click.
Ctrl+click is used to select subobjects (faces, edges, and
vertices) on 3D solids, surfaces, and meshes.
0
Ctrl+click is used to cycle through overlapping objects.
Disallows using Ctrl+click to select subobjects on 3D solids,
surfaces, and meshes.
1
Ctrl+click is used to select subobjects (faces, edges, and
vertices) on 3D solids, surfaces, and meshes when SUB-
2
OBJSELECTIONMODE on page 2553 is set to 0.If SUBOBJSE-
LECTIONMODE is set to 1, 2, 3, or 4, it is not necessary
to hold down the Ctrl key to select subobjects.If you hold
down the Ctrl key when SUBOBJSELECTIONMODE is set
to 1, 2, 3, or 4, the subobject filter is turned off until the
Ctrl key is released.
LENSLENGTH
Quick Reference
See also:
■ Create a Camera
RealType:
DrawingSaved in:
50.0000Initial value:
Stores the length of the lens (in millimeters) used in perspective viewing.
LENSLENGTH | 2401