2012

DYNMODE
Quick Reference
See also:
■ Use Dynamic Input
IntegerType:
RegistrySaved in:
3Initial value:
Turns Dynamic Input features on and off.
When all features are on, the context governs what is displayed.
When DYNMODE is set to a negative value, the Dynamic Input features are
not turned on, but the setting is stored. Press the Dynamic Input button in
the status bar to set DYNMODE to the corresponding positive value.
All Dynamic Input features, including dynamic prompts,
off
0
Pointer input on1
Dimensional input on2
Both pointer input and dimensional input on3
If dynamic prompts are on (DYNPROMPT is set to 1), they are displayed when
DYNMODE is set to 1, 2, or 3.
When dimensional input is turned on (DYNMODE = 2 or 3), the program
switches to pointer input when you enter a comma or an angle bracket (<),
or when you select multiple grip points.
When DYNMODE is set to 1, 2, or 3, you can turn off all features temporarily
by holding down the temporary override key, F12.
Settings are on the Dynamic Input tab in the
Drafting Settings dialog box.
2310 | Chapter 31 D System Variables