2012

draw order inheritance: new objects that are created from
another object using the commands listed below are not
assigned the draw order of the original object. Use this
setting to improve the speed of editing operations in large
drawings. The commands that are affected by inheritance
are BREAK, FILLET, HATCH, HATCHEDIT, EXPLODE, TRIM,
JOIN, PEDIT, and OFFSET.
Turns on the default draw order of objects: after objects
are edited, they are automatically displayed according to
the correct draw order.
1
Turns on draw order inheritance: new objects created
from another object using the commands listed above are
assigned the draw order of the original object.
2
Provides full draw order display. Turns on the correct draw
order of objects, and turns on draw order inheritance.
3
NOTE Full draw order display may slow some editing operations.
DRSTATE
Quick Reference
See also:
■ Recover from a System Failure
(Read-only)
IntegerType:
Not-savedSaved in:
VariesInitial value:
Indicates whether the Drawing Recovery Manager window is open or closed.
Closed0
Open1
DRSTATE | 2301