2012

0 (imperial) or 1 (metric)Initial value:
Controls the vertical position of text in relation to the dimension line.
Centers the dimension text between the extension lines.0
Places the dimension text above the dimension line except
when the dimension line is not horizontal and text inside
1
the extension lines is forced horizontal (DIMTIH = 1). The
distance from the dimension line to the baseline of the
lowest line of text is the current DIMGAP value.
Places the dimension text on the side of the dimension
line farthest away from the defining points.
2
Places the dimension text to conform to Japanese Industrial
Standards (JIS).
3
Places the dimension text below the dimension line.4
DIMTDEC
Quick Reference
See also:
■ Display Lateral Tolerances
IntegerType:
DrawingSaved in:
4 (imperial) or 2 (metric)Initial value:
Sets the number of decimal places to display in tolerance values for the primary
units in a dimension.
This system variable has no effect unless DIMTOL is set to On. The default for
DIMTOL is Off.
DIMTDEC | 2265