2012

Assigns lineweight to extension lines.
Default (the LWDEFAULT value)-3
BYBLOCK-2
BYLAYER-1
The integer represents 1/100th of a mm.
DIMPOST
Quick Reference
See also:
■ Control the Display of Dimension Units
StringType:
DrawingSaved in:
NoneInitial value:
Specifies a text prefix or suffix (or both) to the dimension measurement.
For example, to establish a suffix for millimeters, set DIMPOST to mm; a
distance of 19.2 units would be displayed as 19.2 mm.
If tolerances are turned on, the suffix is applied to the tolerances as well as to
the main dimension.
Use <> to indicate placement of the text in relation to the dimension value.
For example, enter <>mm to display a 5.0 millimeter radial dimension as
"5.0mm". If you entered mm <>, the dimension would be displayed as "mm
5.0". Use the <> mechanism for angular dimensions.
DIMPOST | 2259