2012

Controls whether electronic files (DWF/PDF) are created automatically when
you save or close drawing (DWG) files.
Turns off automatic publishing to DWF/PDF files when a
drawing is saved or closed
0
Turns on automatic publishing to DWF/PDF files when a
drawing is saved or closed
1
The
AUTOPUBLISH command controls additional options.
AUTOSNAP
Quick Reference
See also:
■ Set Visual Aids for Object Snaps (AutoSnap)
IntegerType:
RegistrySaved in:
63Initial value:
Controls the display of the AutoSnap marker, tooltip, and magnet.
Also turns on polar and object snap tracking, and controls the display of polar
tracking, object snap tracking, and Ortho mode tooltips. The setting is stored
as a bitcode using the sum of the following values:
Turns off the AutoSnap marker, tooltips, and magnet. Also
turns off polar tracking, object snap tracking, and tooltips
for polar tracking, object snap tracking, and Ortho mode
0
Turns on the AutoSnap marker1
Turns on the AutoSnap tooltips2
Turns on the AutoSnap magnet4
Turns on polar tracking8
Turns on object snap tracking16
2172 | Chapter 28 A System Variables