2012

Table Of Contents

Sets the Z coordinate value.

Path Type

Select the full (absolute) path, the relative path to the external reference file,

or No Path, the name of the external reference (the file must be located in the

same folder as the current drawing file).

Rotation

Specify on-screen

If Specify On-Screen is selected, you may wait until you exit the dialog box

to rotate the object with your pointing device or at the Command prompt.

Angle

If Specify On-Screen is cleared, enter the rotation angle value in the dialog

box.

Block Unit

Displays information about the block units.

Block Name Displays the name of the block associated with the selected

external reference.

Unit Displays the specified INSUNITS value for the inserted block.

Factor Displays the unit scale factor, which is calculated based on the

INSUNITS value of the block and the drawing units.

Show Details

Displays the external reference file paths.

Found In Displays the path where the external reference file is located.

Saved Path Displays the path that is saved with the drawing when the external

reference is attached. The path is dependent upon the Path Type setting.

External Reference Ribbon Contextual Tab

Quick Reference