2012

Toolbar: Modify
Summary
This command is equivalent to the Polar option in
ARRAY on page 145.
Creates an array by copying the selected objects around a specified center
point or axis of rotation.
List of Prompts
The following prompts are displayed.
Select objects: Use an object selection method
Specify center point on page 160 of array or [Base point on page 160/Axis of
rotation
on page 160]: Specify a center point, or enter an option
Enter number of
items on page 161 or [Angle between on page 161/Expression
on page 161] <last count>: Specify the number of items or enter an option
Specify the
angle to fill on page 161 (+=ccw, -=cw) or [Expression]: Enter a fill
angle or enter an option
Press Enter to accept or [ASsociative on page 161/Base point/Items/Angle
between/Fill angle/
ROWs on page 161/Levels on page 161/ROTate items on page
161/
eXit on page 161]<eXit>: Press Enter or select an option
Center Point
Specifies the point around which to distribute the array items. The axis of
rotation is the Z axis of the current UCS.
Base Point
Specifies a base point for the array.
Key Point For associative arrays, specifies a valid constraint (or key point) on
the source objects to use as the base point. If you edit the source objects of
the resulting array, the base point of the array remains coincident with the
key point of the source objects.
Axis of Rotation
Specifies a custom axis of rotation defined by two specified points.
160 | Chapter 2 A Commands