2012

Representation Panel
This panel is visible only when you are creating a base view from an Inventor
model. Representation types are model specific. Some of the options may not
be available in the selected model.
Design View
Specifies the assembly design view representation to show in the base view
being created.
This option is available only if the selected model is an Inventor assembly
(*.iam) that contains design view representations. It is also not available during
the creation of projected views.
Positional Representation
Specifies the positional representation to show in the base view being created.
This option is available only if you are creating a base view from an Inventor
assembly (*.iam) that contains positional representations. It is also not available
during the creation of projected views.
Level of detail
Specifies the level of detail representation to show in the base view.
This option is available only if the selected model is an Inventor assembly
(*.iam). It is also not available during the creation of projected views.
Weldment Specifies the weldment state to show in the base view. The list
does not explicitly show the preparatory state. Instead, it displays the names
of the components in the pre-welding preparatory state.
This option is available only if the selected model is an Inventor weldment
assembly (*.iam).
Member Specifies which member from an iAssembly factory or iPart factory
to show in the base view.
This option is available only if the selected model is an iAssembly factory or
an iPart factory (*.iam, *.ipt).
Sheet metal Specifies the sheet metal view to show in the base view.
2040 | Chapter 22 V Commands