2012

Select objects or <select all>: Select one or more objects and press Enter, or press
Enter to select all displayed objects
Select the objects that define the cutting edges to which you want to trim an
object, or press Enter to select all displayed objects as potential cutting edges.
TRIM projects the cutting edges and the objects to be trimmed onto the XY
plane of the current user coordinate system (UCS).
NOTE To select cutting edges that include blocks, you can use only the single
selection, Crossing, Fence, and Select All options.
Select object to trim on page 1960 or shift-select to extend on page 1960 or [Fence
on page 1961/Crossing on page 1961/Project on page 1961/Edge on page 1962/eRase
on page 1962/Undo on page 1963]: Select an object to trim, hold down SHIFT and
select an object to extend it instead, or enter an option
Specify an object selection method to select the objects to trim. If more than
one trim result is possible, the location of the first selection point determines
the result.
Object to Trim
Specifies the object to trim.
Shift-Select to Extend
Extends the selected objects rather than trimming them. This option provides
an easy method to switch between trimming and extending.
1960 | Chapter 20 T Commands