2012

Objects that Can Be Used as a Sweep
Path
Objects that Can Be Swept
2D and 3D polylines2D polylines
Solid, surface and mesh edge subobjects2D solids
Helices3D solid face subobjects
ArcsArcs
CirclesCircles
EllipsesEllipses
Elliptical arcsElliptical arcs
LinesLines
Regions
Solid, surface and mesh edge su-
bobjects
Trace
NOTE Select face and edge subobjects by pressing Ctrl while you select them.
To automatically delete the original geometry used to create the object, use
the DELOBJ system variable. For associative surfaces on page 2558, the DELOBJ
system variable is ignored and the originating geometry is not deleted.
List of Prompts
The following prompts are displayed.
Objects to Sweep Specifies an object to use as the sweep profile.
Sweep Path Specifies the sweep path based on the object you select.
Mode Controls whether the sweep action creates a solid or a surface. Surfaces
are swept as either NURBS surfaces or procedural surfaces, depending on the
SURFACEMODELINGMODE on page 2560 system variable.
SWEEP | 1883