2012

Enter a vertex editing option [Add on page 1830/Delete on page 1830/Elevate order
on page 1830/Move on page 1830/Weight on page 1830/eXit on page 1830] <eXit>:
Add
Adds a new control vertex at the point you specify that is located between
two existing control vertices.
Delete
Removes a selected control vertex.
Elevate Order
Increases the polynomial order (degree plus one) of the spline. This results in
increasing the number of control vertices across the spline.
The maximum value is 26.
Move
Relocates a selected control vertex.
■
New Location on page 1829
■ Next on page 1829
■ Previous on page 1829
■ Select Point on page 1829
Weight
Changes the weight of a specified control vertex.
New Weight Recalculates the spline based on the new weight value for the
specified control vertex. A larger value pulls the spline closer to the control
vertex.
■ Next on page 1829
■ Previous on page 1829
■ Select Point on page 1829
Exit
Returns to the previous prompt.
Convert to Polyline
Converts the spline to a polyline.
The precision value determines how closely the resulting polyline matches
the spline. Valid values are any integer between 0 and 99.
1830 | Chapter 19 S Commands