2012

Table Of Contents

Tolerance Specifies the distance by which the spline is allowed to deviate

from the specified fit points. A tolerance value of 0 requires the resulting spline

to pass directly through the fit points. The tolerance value applies to all fit

points except the starting and ending fit points, which always have a tolerance

of 0.

Options for Splines with Control Vertices

The following option is specific to the control vertices (CV) method.

(

SPLMETHOD on page 2546 system variable)

Degree Sets the polynomial degree of the resulting spline. Use this option to

create splines of degree 1 (linear), degree 2 (quadratic), degree 3 (cubic), and

so on up to degree 10.

SPLINEDIT

Quick Reference