2012

Access Methods
Button
Ribbon: Home tab ➤ Modeling panel ➤ Solid Drawing
Menu: Draw ➤ Modeling ➤ Setup ➤ Drawing
Summary
After using SOLVIEW, visible and hidden lines representing the silhouette
and edges of solids in the viewport are created and then projected to a plane
perpendicular to the viewing direction.
List of Prompts
The following prompts are displayed.
Select viewports to draw ...
Select objects: Select the viewports to be drawn
SOLDRAW can only be used in viewports that have been created with
SOLVIEW.
Visible and hidden lines representing the silhouette and edges of solids in the
viewport are created and then projected to a plane perpendicular to the viewing
direction. Silhouettes and edges are generated for all solids and portions of
solids behind the cutting plane. For sectional views, cross-hatching is created
using the current values of the HPNAME, HPSCALE, and HPANG system
variables.
Any existing profiles and sections in the selected viewport are deleted, and
new ones are generated. All layers, except those required to display the profile
or section, are frozen in each viewport.
WARNING Do not place permanent drawing information on the view name-VIS,
view name-HID, and view name-HAT layers. The information stored on these layers
is deleted and updated when SOLDRAW is run.
To undo a viewport drawn by SOLDRAW, you must use the Back option of
UNDO.
NOTE SOLDRAW is defined by the acsolids.arx application and is intended to be
used only interactively. For more information, see Externally Defined Commands.
SOLDRAW | 1785