2012

Table Of Contents

With the FILEDIA system variable set to 0 (or if you are running a script or

other automation), enter -publish or +publish at the Command prompt. The

following prompt is displayed:

List of Prompts

The following prompts are displayed.

Enter name of sheet list <path file name.dsd>: Press ENTER for the current drawing

or enter the sheet list name

NOTE The bracketed text <DSD file name> contains the name of the DSD file

used when this command was last run. The bracketed text area is blank if no

previous name exists. If you enter a tilde (~) for the file name, the standard file

selection dialog box is displayed regardless of the FILEDEA setting.

The file name is validated and the list of sheets is loaded.

When -PLOT, PLOT, -PUBLISH, and PUBLISH are used in a script (SCR file),

the BACKGROUNDPLOT system variable value is ignored, and -PLOT, PLOT,

-PUBLISH, and PUBLISH are processed in the foreground.

Once the publish job starts, each drawing sheet name is listed along with an

appropriate message. Drawing sheets not found or not initialized are indicated

with an error message.

When the publish job is complete, the details can be viewed in the

Plot and

Publish Details dialog box

A log file is written during the publish operation. The log file contains the

drawing sheet name, layout name, full drawing name, path name, and status.

The log file name is derived from the name of the sheet list file with CSV

replacing the DSD file extension.

NOTE Any existing log file is overwritten by a new log file without any warning

message being displayed.

PUBLISHTOWEB

Quick Reference