2012

With the POLYSOLID command, you can convert an existing line, 2D polyline,
arc, or circle to a solid with a rectangular profile. A polysolid can have curved
segments, but the profile is always rectangular by default.
You can draw a solid with POLYSOLID just as you would a polyline. The
PSOLWIDTH system variable sets the default width for the solid. The
PSOLHEIGHT system variable sets the default height for the solid.
List of Prompts
The following prompts are displayed.
Specify start point or [
Object on page 1537/Height on page 1537/Width on page
1538/
Justify on page 1538] <Object>: Specify a start point for the profile of the solid,
press Enter to specify an object to convert to a solid, or enter an option
Specify the next point on page 1538 or [Arc on page 1539/Undo on page 1539]: Specify
the next point for the profile of the solid, or enter an option
Object
Specifies an object to convert to a solid. You can convert:
■ Line
■ Arc
■ 2D polyline
■ Circle
Select object: Select an object to convert to a solid
Height
Specifies the height of the solid. The default height is set to the current
PSOLHEIGHT setting.
Specify height <default>: Specify a value for the height, or press Enter to specify
the default value
POLYSOLID | 1537