2012

You can use the Width option of the Edit Vertex option to change the starting
and ending widths of a segment.
Edit Vertex
Marks the first vertex of the polyline by drawing an X on the screen. If you
have specified a tangent direction for this vertex, an arrow is also drawn in
that direction.
Next
Moves the X marker to the next vertex. The marker does not wrap around
from the end to the start of the polyline even if the polyline is closed.
Previous
Moves the X marker to the previous vertex. The marker does not wrap around
from the start to the end of the polyline even if the polyline is closed.
Break
Saves the location of the marked vertex while you move the X marker to any
other vertex.
If one of the specified vertices is at an end of the polyline, the result is one
truncated polyline. If both specified vertices are at endpoints of the polyline,
or if just one vertex is specified and it is at an endpoint, you cannot use Break.
■ Next on page 1451
■ Previous on page 1451
Go Deletes any segments and vertices between the two vertices you specify
and returns to Edit Vertex mode.
2D Polyline Selection (PEDIT) | 1451