2012

Insertion Point
Specifies the insertion point for the selected PDF file.
Specify On-Screen
Directs input at the Command prompt or the pointing device.
X
Sets the X coordinate value.
Y
Sets the Y coordinate value.
Z
Sets the Z coordinate value.
Scale
Specifies the scale factor of the selected PDF underlay.
If
INSUNITS is set to “unitless” or if the underlay does not contain resolution
information, the scale factor becomes the underlay width in AutoCAD units.
If INSUNITS has a value such as millimeters, centimeters, inches, or feet, and
the underlay has resolution information, the scale factor is applied after the
true width of the underlay in AutoCAD units is determined.
Specify On-screen
Inputs information at the Command prompt or with the pointing device. If
Specify On-Screen is cleared, enter a value for the scale factor.
Scale Factor Field
Enter a value for the scale factor.
Rotation
Specifies the rotation angle of the selected DWF underlay.
Specify on-screen
If Specify On-Screen is selected, you may wait until you exit the dialog box
to rotate the object with your pointing device or enter a rotation angle value
at the Command prompt.
Angle
If Specify On-Screen is cleared, enter the rotation angle value in the dialog
box. The default rotation angle is 0.
Attach PDF Underlay Dialog Box | 1443