2012

List of Prompts
The following prompts are displayed.
Corner = current
Select face: Select a planar face on a 3D solid or surface
Specify through point or [Distance/Corner] <current>: Specify a point, or enter
an option
Through Point
Creates an offset object that passes through the specified point. This point is
always projected line-of-sight onto the plane of the selected face.
Distance
Creates an offset object at a specified distance from the edges of the selected
face.
Specify distance: <current> Enter the offset distance, or press Enter to accept
the current distance.
Specify point on side to offset Specify a point location to determine whether
the offset distance is applied inside or outside the edges of the face.
Corner
Specifies the type of corners on the offset object when it is created outside the
edges of the selected face.
Sharp Creates sharp corners between offset linear segments.
Rounded Creates rounded corners between offset linear segments, using a
radius that is equal to the offset distance.
1302 | Chapter 15 O Commands