2012

Edits the number in the lower part or second half of a stacked fraction.
Appearance
Edits the style, position, or text size of a stacked fraction.
Style
Specifies a style format for stacked text: horizontal fraction, diagonal fraction,
tolerance, and decimal.
Fraction (Horizontal) Stacks the selected text with the first number on top
of the second number separated by a horizontal line.
Fraction (Diagonal) Stacks the selected text with the first number on top of
the second number separated by a diagonal line.
NOTE Releases of AutoCAD earlier than AutoCAD 2000 do not support diagonal
fractions. If a multiline text object contains diagonal fractions, the fractions are
converted to horizontal fractions when you save the drawing to pre-AutoCAD
2000 releases. Diagonal fractions are restored when the drawing is re-opened in
AutoCAD 2000 or a later release. If a single multiline text object contains both
horizontal and diagonal fractions, all fractions are converted to diagonal fractions
when the drawing is reopened in AutoCAD 2000 or a later release.
Tolerance Stacks the selected text with the first number on top of the second
number. There is no line between the numbers.
Decimal A variation of the Tolerance style that aligns the decimal point of
both the upper and lower numbers of selected text.
Position
Specifies how fractions are aligned. Center alignment is the default. All stacked
text in an object uses the same alignment.
Top Aligns the top of the fraction with the top of the text line.
Center Centers the fraction vertically at the center of the text line.
Bottom Aligns the bottom of the fraction with the text baseline.
Text Size
Controls the size of the stacked text as a percentage of the size of the current
text style (from 25 to 125 percent).
Defaults
Saves the new settings as defaults or restores the previous default values to
the current stacked text.
Stack Properties Dialog Box | 1251