2012

Point Selection Sets placement for the text box for the text label associated
with the multileader object. When you finish entering your text, click OK or
click outside the text box.
If you choose End at this point, then no landing line is associated with the
multileader object.
Options
Specifies options for placing the multileader object.
Leader Type Specifies a straight, spline, or no leader line.
■ Straight.
■ Spline.
■ None.
Leader Landing Changes the distance of the horizontal landing line
■ Yes.
■ No.
If you choose No at this point, then no landing line is associated with the
multileader object.
Content Type Specifies the type of content that will be used for the
multileader.
■
Block on page 1190
■
Mtext on page 1190
■
None on page 1190
Block Specifies a block within your drawing to associate with the new
multileader.
■ Enter block name.
Mtext Specifies that multiline text is included with the multileader.
■ Enter the multiline text.
None Specifies no content type.
Maxpoints Specifies a maximum number of points for the new leader line.
■ Enter the maximum points for leader line.
1190 | Chapter 13 M Commands