2012

Corner Sets the scale factor by using the block insertion point and the opposite
corner.
■
Specify Rotation Angle on page 1180
■
Number of Rows/Columns on page 1180
■
Distance Between Rows on page 1180
■
Distance Between Columns on page 1180
XYZ Sets X, Y, and Z scale factors.
■
X Scale Factor on page 1180
■
Corner on page 1181
■
Specify Rotation Angle on page 1180
■
Number of Rows/Columns on page 1180
■
Distance Between Rows on page 1180
■
Distance Between Columns on page 1180
Basepoint
Temporarily drops the block in the drawing where it is currently positioned
and allows you to specify a new base point for the block reference as it is
dragged into position. This does not affect the actual base point defined for
the block reference.
Scale
Sets the scale factor for the X, Y, and Z axes. The scale for the Z axis is the
absolute value of the specified scale factor.
■ XYZ on page 1181
■ Specify Rotation Angle on page 1180
■ Number of Rows/Columns on page 1180
■ Distance Between Rows on page 1180
■ Distance Between Columns on page 1180
X
Sets the X scale factor.
■
Specify Rotation Angle on page 1180
MINSERT | 1181