2012

You can also apply creases to mesh subobjects by changing the crease type
and crease level in the
Properties palette on page 1545.
List of Prompts
The following prompts are displayed.
Select mesh subobjects to crease Specifies the mesh subobjects to crease.
Click mesh faces, edges, and vertices to crease their associated edges. Press
Shift+click to remove a subobject from the selection set.
■
Crease value
■ Always
Crease value Sets highest smoothing level at which the crease is retained. If
the smoothing level exceeds this value, the crease is also smoothed.
Enter a value of 0 to remove an existing crease.
Always Specifies that the crease is always retained, even if the object or
subobject is smoothed or refined. A crease value of -1 is the same as Always.
MESHCREASE | 1149