2012

Table Of Contents

Start Magnitude

Controls the relative distance of the surface from the start cross section in the

direction of the draft angle before the surface starts to bend toward the next

cross section. (LOFTMAG1 system variable)

End Angle

Specifies the draft angle for the end cross section. (LOFTANG2 system variable)

End Magnitude

Controls the relative distance of the surface from the end cross section in the

direction of the draft angle before the surface starts to bend toward the previous

cross section. (LOFTMAG2 system variable)

Close Surface or Solid

Closes and opens a surface or solid. When using this option, the cross sections

should form a torus-shaped pattern so that the lofted surface or solid can form

a closed tube. (LOFTPARAM system variable)

Periodic (Smooth Ends)

Creates a smooth, closed surface whose seam will not kink if it is reshaped.

This option is only available if the loft is ruled or smooth fit and the Close

Surface or solid option is selected.

LOGFILEOFF

Quick Reference