2012

When creating surfaces, use SURFACEMODELINGMODE on page 2560 to control
whether the surface is a NURBS surface or a procedural surface. Use
SURFACEASSOCIATIVITY on page 2558 to control whether procedural surfaces
are associative.
You can use the following objects and subobjects with LOFT:
Objects That Can Be
Used as Guides
Objects That Can Be
Used as a Loft Path
Objects That Can Be
Used as Cross Sec-
tions
2D splineSpline2D polyline
2D solid
3D splineHelix2D spline
ArcArcArc
2D polylineCircleCircle
NOTE 2D polylines
can be used as guides
if they contain only 1
segment.
Edge subobjectsEdge subobjectsEdge sub-objects
3D polylineEllipseEllipse
Elliptical arcElliptical arcElliptical arc
2D polylineHelix
LineLineLine
Planar or non-planar
face of solid
Planar or non-planar
surface
3D polylinePoints (first and last
cross section only)
1062 | Chapter 12 L Commands