2012

Endpoint of Line Draws a straight line from the previous point to the specified
new point. The prompt is repeated until you press Enter to end the command.
Undo Deletes the last line created. You can continue drawing from the previous
point.
Close Draws a closing line from the endpoint back to the first point, and then
ends the command. To be closed, a 3D polyline must contain at least two
lines.
3DPRINT
Quick Reference
See also:
■ Print 3D Models
Sends a 3D model to a 3D printing service.
Access Methods
Button
56 | Chapter 1 3D Commands