2012

Rename
Renames an existing layer.
On
Makes selected layers visible and available for plotting.
Off
Makes selected layers invisible and excludes them from plotting.
Color
Changes the color associated with a layer. Enter a color name or a number
from 1 through 255.
True Color Specifies a true color to be used for the selected object. Enter three
integer values from 0 to 255 separated by commas to specify a true color.
Color Book Specifies a color from a loaded color book, guide, or set to use for
the selected object. Enter the name of a color book that has been installed,
such as "DIC COLOR GUIDE(R)$DIC 43".
The color is assigned to the layer or layers, and the layers are turned on. To
assign a color but turn off the layer, precede the color with a minus sign (-).
Ltype
Changes the linetype associated with a layer.
Lweight
Changes the lineweight associated with a layer.
If you enter a valid lineweight, the current lineweight is set to the new value.
If you enter a lineweight that is not valid, the current lineweight is set to the
nearest fixed lineweight value. If you would like to plot an object with a
custom width not found in the list of fixed lineweight values, you can use the
Plot Style Table Editor to customize plotted lineweights.
Transparency
Changes the transparency level associated with a layer. Enter a value from 0
to 90.
After specifying a transparency value, the following prompt is displayed:
Enter name list of layer(s) for transparency specified value% <0>: Enter the names
of the layers to which to apply this transparency level, or press Enter to apply it to the
current layer only
Material
Attaches a material to a layer. The material must be available in the drawing
before it can be assigned to a layer.
1002 | Chapter 12 L Commands