2012

If you define a single selection set, INTERFERE checks all the solids in the set
against one another. If you define two selection sets, INTERFERE checks the
solids in the first selection set against those in the second selection set. If you
include the same 3D solid in both selection sets, INTERFERE considers the 3D
solid part of the first selection set and ignores it in the second selection set.
Pressing Enter starts the interference testing of pairs of 3D solids and displays
the
Interference Checking dialog box.
If you enter -interfere at the Command prompt,
options are displayed.
List of Prompts
The following prompts are displayed.
First set of objects Specifies a set of objects to be checked. If you do not select
a second set of objects, all objects in this selection set are checked against each
other.
■ Second set of objects
■ Nested selection
■ Settings
Second set of objects Specifies an additional set of objects to be compared
against the first set of objects. If you select the same object twice, the object
is handled as part of the first selection set.
■ Second set of objects
■ Nested selection
■ Check first set. Initiates interference checking for only the first selection
set and displays the Interference Checking dialog box.
962 | Chapter 10 I Commands